For those of you who are unfamiliar or less understood in terms of the electrical installation, but want to learn how to connect the cable to plug it in this post I will share a simple experience that hopefully can add to your knowledge. There are several forms of the plug on the market but on the same principle, namely how to keep the flow of electricity from a wall outlet plug that can be connected with listrikpun eventually be forwarded by the cable plug to connect to it.
There are two types of plugs are generally used and sold in stores electrical appliances that are shaped flat and slightly rounded shape.
The plug is shaped flat
With a flat shape like this can be ensured that the plug can only be connected with two wires consisting of the phase / positive / negative cable fire and / neutral, the cable used is a manifold fibers. This type of plug is usually used as electrical connecting cables for electronic equipment that uses fiber cable. The installation for this type of plug is easy just by connecting the two wires to each connector in the plug, the way is to follow the shape of the connector is no connector directly to the wound and fastened with screws and there were inserted into the back of the plug finger then boosted with a small baud.
How to install a cable to plug in the form of flat:
1 Peel off the two wires to copper wires are visible in it with a length of approximately 1cm then twisted the wire in order to facilitate the installation of the plug. 2 Open the screw plug that into two parts.
3. wrap the two wires that have been pared to the connector inside the plug and tighten the screws.
4 Replace both the plug and do not forget to put back the screw.
The plug is a round (plus ground)
When viewed directly physically plug type is equipped with two small plate which serves to connect the grounding cable / grounding to stopcontact, other than that this is a function of the plate as a brace for the plug to plug into a power outlet is not easily separated from the outlet hole, when the plug is opened then will look three connectors for cable and plastic cable clamp that locks function that does not move so that the connector to the cable connection is not interrupted. The plug is useful for the installation of three wires consisting of: positive cable (black), negative cable (blue, and cable grounding / earthing (yellow or yellow green strip), but did not rule out this type of plug fitted to two wires without grounding .
How to install a cable to plug that is round (plus ground)
1 Prepare the cable to be spliced, the third peeled end of the cable to look for copper wire is approximately 1cm.
2 Open body / body then remove the plastic plug with a cord lock to loosen both screws.
3 Loosen the screw connectors attached to the rear end of the plug and baud fingers are mounted on a plate in the middle.
4. enter the blue copper wire and copper wire to the black connector plug located on the second finger.
5. Connect the yellow wire to the connector in the middle and tighten the screw.
6 Attach the locking cable to cable then press kencangk both screws.
If you do not wear or do not require grounding wire / grounding but want to use this type of plug, the only two cables connected to the second connector plug finger while the middle connector that serves as a fitting ground wires ignored.
This type of plug can be used for cables or a single fiber type, when you use stranded cable to connect this plug to the first gyre before being connected to the copper wire into the fibers to facilitate the installation and prevent the fibers partially detached and short-circuit with another cable.
No comments:
Post a Comment