Many people who submitted their affairs of the electrical installation to installers services with considerable cost, to those of you who want a little cut electrical installation expenses you can install on your own at home by studying installation techniques, my description below is one simple example , for a development adapted to the shape of the house is built, please note that the electrical installation is installed after a house has been installed KWH and MCB by PLN. for those of you who want to learn the electrical installation phases please read below:
Make planning drawings for electrical lines, for a new home built from scratch, plan position switch, outlet and light fittings before the house was built as early stages of electrical installation carried out after installation and before the installation of stucco brick wall, that's when installed pipes for electrical wiring the walls were not plastered.
Installation of pipes for electrical wiring, cable install plumbing in the wall that has not been plastered follows tedus, tedus this is the place to put the switch or outlet that attaches strong walls. For the plastered walls were not for this pipeline stucco must be removed first by means unloaded using a chisel, measure the height tedus that suits your needs.
Main line cabling, installation of main lines in pairs starting from where the cord exits from the outlet end of the MCB to last, this pathway is mounted on a wooden ceiling electrical pipe passes out of the wall.
Splicing light cable, switch and outlet. Connect all the cables correctly and safely, optimally measure the length of the cable, not until after installed was not able to reach the screw terminals on the lamp fittings, switch or receptacle, cable use as intended.
Installation of switches, and outlet, this is done after the installation of electric pipe closed and topical stucco walls are neatly painted, close any open connections using special insulation for electrical wires, attach each end of the cable that is attached to each terminal screw firmly to avoid layout changes which resulted in a surge of electrical current and connectedness.
Installation of lights and their light fittings, light fittings attach firmly attached to the ceiling because these fittings will withstand a light load, use the appropriate fittings to the type of lighting that will be installed for each lamp has a different heat, light fittings made of plastic material thin easy to melt by heat lamps.
The process of testing, try turn followed MCB lighting throughout and insert the plug electronic devices into any outlet, the installation is considered successful when all the lights can be switched on and off by a switch normally and all the outlet can be turned on / used electronic devices.
No comments:
Post a Comment