HOW TO MAKE A CABLE ARDE (GROUNDING)

I created this writing because of the installation of the grounding wire (grounding) in almost every house blend with an electric cable lines negative / neutral from the electricity grid. Before we get into the subject helps us to know first the benefits of this cable, such as:

     Neutralize stun exist in electronic devices such entity on a computer, refrigerator, electric strika, etc., when the lat allA body grounding cable connected to the body of the electronic device will not nyetrum again when in contact with our skin.
     Dispose of electrical sparks that usually appears at the outlet of the plug mounted electronic device that large electric power.

"For electronic devices such as computers, the body must not be connected to the negative power (neutral) for fear it would damage the components inside" With one of these reasons (there may be other reasons) then the grounding wire should be completely separated or not combined with cable negative / neutral.

Equipment needed to make the grounding wire lines

     combination pliers
     hammer
     crowbar

The materials required:

     NYM cables size of 2.5 mm, yellow try to be easy to distinguish with other cables to facilitate the installation.
     Iron pipe .. to 900 watts of electricity to power at least 150cm in length or longer is better.
     nail clamp to taste

  How to install:

Click on image
to enlarge

Select a location to plant iron pipe into the ground, try the area near the house seleliling land surface is visible, when the ground was covered walls around our property or ceramic dibobok it must be used in order to be able to freely enter the pipe into the ground.
     pipe plug in place that is already selected, uses a hammer to plant a pipe into the ground to a depth that we want.
     Connect the cable NYM peeled to the end of the iron pipe that has been embedded into the ground.
     Connect NYM cable that is connected to the tip of the iron pipe to each outlet grounding terminal.